Click to go to Forum Home Click to go to maXbimmer Home

Go Back   maXbimmer Forums > maXimum Tech > Forced Induction
User Name
Password


Welcome to Maxbimmer.com!

You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

 
 
Thread Tools Rating: Thread Rating: 3 votes, 3.67 average. Display Modes
Prev Previous Post   Next Post Next
Old 07-18-2011, 10:03 PM   #15
Bullet Ride
Cars in Perpetual Repair
 
Bullet Ride's Avatar
 
Join Date: Nov 2007
Location: Guelph
Posts: 5,749
Back from the dead....

Any MS guys here have any experience with the LM1815 VR Conditioner circuit?

Last year I had an issue with my DIYPNP where the car wouldn't rev past 2500rpm. I checked my tooth log and noticed some irregular noise and I was getting sync loss error code #2. I tried noise filtering to no avail. After speaking with Matt Cramer he recommended switching to the LM1815 circuit. However winter rolled around and the car got put away.

Fast forward to this year, I took the car out of storage a few weeks ago. It fired right up with no issues, still with the same problem as last year not being able to rev past 2500rpm. So I decided to try and switch over to the LM1815

Last year Matt had pointed me to this application document for an example of how to implement the circuit (http://www.diyautotune.com/diypnp/ap...-5vzfe-mt.html). I wired the VR+ input on the connector board to the VR+ on the LM1815 circuit and the VR- input on the connector board to the VR- on the LM1815. Then I wired the LM1815 Out to Relay 3 In and Relay 3 Out to Opto+ and I installed the Opto ground jumper. I tried starting the car and now it's not getting a cranking signal so the car won't start.

Is this the way it's supposed to be wired? Was I supposed to keep the 18k resistor in series with the VR+ input (I removed it)? Do any changes need to be made in the TunerStudio Settings.

Any help advice would be greatly appreciated
__________________

Last edited by Bullet Ride; 07-18-2011 at 10:15 PM.
Bullet Ride is offline   Reply With Quote
 

Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -4. The time now is 08:09 PM.


Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Maxbimmer Copyright 2001 - 2014