Amp Trouble

vegabass · 02-16-2010, 07:21 PM

Hey Guys,

I have a rockford fosgate p10002 amplifier that powers up, gets an input signal, but there is no output. The subs are fine, i tried them with a different amp. I checked the wires. I noticed that if i disconnect one wire from a sub and touch it to the terminal again, it sparks.

Anyone have any ideas?

tg07lq · 02-16-2010, 10:06 PM

signal from rcas good?> put a meter on output term and get reading?

vegabass · 02-17-2010, 01:16 AM

Quote:

Originally Posted by tg07lq

signal from rcas good?> put a meter on output term and get reading?

yup signal is good, the amp has two leds that light up when there is signal. i am completely stumped.

Robb · 02-17-2010, 01:34 AM

Take it out and get the amp tested for free at www.s-selectronics.com

tominizer · 03-30-2010, 07:24 AM

If you've installed another amp in the same setup and it works, sounds like the amp in pouched and you need to get a new amp. Electronics have a lifespan......... or an abuse-span ...... LMAO !!

vegabass · 06-30-2010, 02:44 AM

Not sure what ^^^ is,

Thanks Robb, i headed to these guys and they took care of it for me. Turns out i had blown the output transistors.

They fixed for me and the day i was going to re-install it, my brother wrote of the car. Go figure lol. Sorry for the late thank you

Quote:

Originally Posted by Robb

Take it out and get the amp tested for free at www.s-selectronics.com