I had those exact ones on the front of my e30. I paid 10 bucks a pop down on Danforth. Ordered bolts that were a couple of threads longer. Mounting them was tricky. Either tape the spacer to the inside of the wheel or right on the brake disk making sure its center. Then blot the wheel up looking through the center cap to align, trying to get it as hub centric as possible. Just make sure the spacer is perfect in between the wheel and the brake disk as it will rub on the caliper bracket due to little clearance. I ran this set up for a while, hit every dam pothole and never had a problem
I have used them too. The Dealz for Wheelz on Merivale by Costo sell them (some need to be ordered tho) and typically stock longer bolts.
If your wheels use a centering ring it can actually work out really well, since most rings have a standard outer diameter which is the same as the spacers. You can wedge the ring inside the spacer, use the BMW wheel holder to hold in place and slide the wheel on. I have used 3mm, 5mm, 8mm and 12mm this way without problems! Make sure you use a torque wrench to tighten the lugs to ensure a good fit.
I don't think they strictly _need_ spacers... they do fit as is. They're just very close to the struts (like no more than 2-3mm clearance at the inside lip of the wheel). Maybe in part because of how much my car is lowered, but I'm not sure.
I may take you up on test fitting those spacers at some point - I think the 3mm is probably enough.
Still need to get some hub rings if I decide to keep them though.
Last edited by Duct_Taper; 04-02-2009 at 01:09 PM.
I think 6mm more offset would be asking for trouble. I would run them like this, or try 3mm spacers at the most.
The problem is the tire is so close to the fender, that if during any kind of corner and the suspension moves up, your tire will chew up part of your fender. It can happen with 7" ET25 easily (ask me how I know) and 8" ET20 is 18mm close.
One difference is you have 205/40, whereas I have 215/40, but still.
The 3mms are on my e90 which are coming off this weekend if you'd like to borrow them at some point. I won't need them until I get my wheels on after I'm done the turboh.
Yeah, pretty much agree. I think it would probably be okay to run as-is... I just don't know exactly how much space I have in there, except that it's not much. I'm planning to roll the fenders as well so I'm not as concerned with clearance at the wheelwell - particularly with the smaller (width and diameter) tires.
I might try and borrow those 3mm for a test fit later - I'm out of town from this Sunday to next Friday, but maybe sometime that weekend or the week after at some point?
On a really funny note, for anyone who watches Doctor Who. They used wheel spacers inside the Tardis to route some cables, lol.. I meant to get a screen grab from the show I saw it in, but here's a shot I found on the web. To the right of the guy's head. (I think he's a writer or something.)