clutch not disengaging fully!

[rider-.]

hey guys, so yesterday my clutch started acting up, i press the clutch pedal but the clutch doesnt disengage fully, so it is very hard to get it in gear, the clutch is only a couple months old, so i doubt that anything happened to it, so my mind is kind of boggled towards what could have come up all of the sudden, i checked the fluid and its full, and the clutch was bled properly when it was installed, any ideas?

[InfiniteDice]

Did you put a new release bearing on? That is what actually slides and engages the clutch. The splines of the shaft when re-installed needs to be greased as well.

[dcramer]

Start with the simple things, bleed it again.

Dave

[Renboy]

Also check to make sure the nipple on the end of the slave cylinder hasn't broken. Relieve pressure before removing the slave.

[rider-.]

K so i still have the same problem after replacing the slave cylinder and bleeding it. How would i know if it is the clutch fork without physically pulling the tranny. I dont underdstand how it would get worse and worse over a week until it didnt engage at all though. Only thing that made sense is hydrolics but the slave is working and the pedal feels fine, i dont think anything is leaking either, only other thing could be that something physically broke on the master. Anyways, your thoughts?

[Renboy]

Have you noticed any leaks by the clutch pedal?

[Ceeker]

Sounds like the release bearing hanging up. take back to shop and have them inspect if a shop installed it they should be the ones to correct it.