View Single Post
Old 11-21-2003, 12:38 AM   #3
crazyvadim
6th Gear Member
 
crazyvadim's Avatar
 
Join Date: Nov 2003
Location: New York
Posts: 2,167
Send a message via AIM to crazyvadim
Not a hard job,if you have some expierence anda service manual then it will go fine.Make sure you apply force to the correct bearing race or else bearing damage will occur if its jammed or incorrect race is pressed into the bearings.Also before installing new bearings,pack them with grease unless they are sealed already with grease.
crazyvadim is offline   Reply With Quote