View Single Post
Old 09-05-2011, 08:58 PM   #264
Bullet Ride
Cars in Perpetual Repair
 
Bullet Ride's Avatar
 
Join Date: Nov 2007
Location: Guelph
Posts: 6,002
Quote:
Originally Posted by craz azn View Post
Sure it could. There is a big enough edge on the pedal that I could weld a small 6mm nut on there (even an 8mm nut would be fine, but thats overkill I think) and have tons of travel for a bolt. You haven't seen the assortment of nicely plated hardware I have access too either
True, without seeing a picture of the back side of the pedals (unless that was on a previous page and I missed it) it's hard to tell what's going on back there, but I see where you're coming from now.
__________________
Bullet Ride is offline   Reply With Quote