View Single Post
Old 03-13-2006, 05:45 PM   #8
6th Gear Member
Join Date: Dec 2003
Location: Ottawa, ON
Posts: 1,876
Originally Posted by Bruno
Lol ... I'm using the exact hoist right now to hold the engine up while I remove the oil pan (to weld the pump nut!). Out of curiosity, what did you use for the rear chain attachment? There does not seem to be anything there, so I had to jimmy up a rig

Originally Posted by Bruno
Don't forget that there is a bolt on the passenger side at the back of the tranny holding a shield. (10mm wrench). If you are removing the tranny.
You still have shields? ... this is a race car, right?

(good tip for the street cars though)
2007 BMW 328Xi Touring, 6 speed
ScotcH is offline   Reply With Quote