Thread: My Restoration
View Single Post
Old 07-24-2005, 07:50 PM   #25
325iSBimmer
///MMMM VIDA
 
325iSBimmer's Avatar
 
Join Date: Feb 2003
Location: Aurora/London
Posts: 1,399
Send a message via MSN to 325iSBimmer
Quote:
Originally Posted by 635CSi
I havent had any major problems other than what already there, if you are going to do some welding I would recommend do all of that first and than just before you start doing the body work strip it down. I had a hard time with chemical stripping cause there was 4-5 coats of paint on the body, so it was eaisier to sand it down, I didnt grind it I used 80 grit on a orbital sander.
would u recomend to sand blast the areas that have some surface rust but dont go through with a hole and the coat it with a rust inhibitor like POR or something that neutralizes it?
__________________
UNDER CONSTRUCTION
325iSBimmer is offline   Reply With Quote