View Single Post
Old 11-13-2002, 01:15 PM   #5
Autotechnica
BMW Traitor
 
Join Date: Dec 2001
Location: Richmond Hill, Ont
Posts: 4,988
Send a message via MSN to Autotechnica
Quote:
Originally posted by KIRASIR
This doesn't make sense since the bushings can be changed without taking the arms off. You just need a special tool to put the new bushings onto the arms. I believe Charlie has it for sure.
With the tool, and on a hoist, it takes about an hour to change the bushings.

Serge

Serge,

Actually the middle bushing and inner bushing of the control arm on the inside has to be change on the driver side. So I think removal of the control arm is necessary correct? Are all 3 bushings on the control arm $40 each? I'm getting a strange noise when I corner hard turning right only, and quite a bit of understeer, do you think it could be cased by the worn busings on the control arm?

Thanks!

Bryan
__________________
'02 C32 AMG @ 18psi - Eurocharged custom ECU/TCU, ASP 178mm crank pulley + NW PSK, CM30 i/c pump, NW i/c iso kit, EC i/c, Magnecore wires, NW CAI, SL55 Y pipe, NW ported intake manifolds + gaskets/spacers, NW inconel exhaust manifolds, NW catch can, dual exhaust, H&R sways, H&R coilovers, H&R spacers, Quaife ATB LSD, goodridge lines, EBC yellowstuff, AMG 18" rims, Zeitronix datalogger.

Autotechnica is online now   Reply With Quote