Steve, here is my version of the rad support as well. Frankie's is different to mine which you will see when he figures out how to use the forum haha
Yes I went a "little" overkill with the bolts using 6 m6's per plate lol.
The only modification I had to make outside of this was notch the plastic grills in the front and the headlight brackets a tiny bit. It all goes back together and looks completely stock from the outside. This will work for stock motor setups.
Too bad I now need to cut it apart and remake the center section out of tubing and be able to tilt my rad by about 20deg for my project, ah well.