View Single Post
Old 02-12-2013, 01:00 PM   #280
craz azn
6th Gear Member
craz azn's Avatar
Join Date: Feb 2004
Location: Port Perry
Posts: 7,631
Send a message via MSN to craz azn
Yeah the holes shouldn't be threaded otherwise it wouldn't tighten up properly.

If you can get a machine shop to skim it down a few tenths of a mm or so, it probably wouldn't hurt the alignment of anything, nor compromise its strength.

As for the oil, how does the main seal look? Is it just as dirty as the flywheel?

Rippin' Proper | Youtube | Vimeo |
craz azn is offline   Reply With Quote