View Single Post
Old 12-21-2012, 07:02 PM   #4
2nd Gear Member
_JohnnyD_'s Avatar
Join Date: Jul 2010
Location: The Creek
Posts: 177
Burning them out is a messy process. Its a pain in the a$$ to clean out the melted rubber from the holes for the bushings in the control arms. The sub frame bushings have a steel sleeve that you'll need to cut out once your done burning the rubber. I had mine pressed out and new bushings pressed in at Lock St. Auto in Hamilton but his price was far from reasonable.

Good luck.
“Life is a series of experiences, each one of which makes us bigger, even though sometimes it is hard to realize this...”

Henry Ford
_JohnnyD_ is offline   Reply With Quote