View Single Post
Old 07-19-2012, 10:32 PM   #210
cormier
6th Gear Member
 
cormier's Avatar
 
Join Date: Feb 2008
Location: St. George, ON
Posts: 1,607
Bit of progress over the last few days

Got the rack bolted up! No modification to the knuckle necessary. New guibo and hardware as well.

Strut assemblies back in with UUC camber plates

On the engine side: UUC st.2 flywheel, clutch, pressure plate installed. Tranny mounted after new T/O bearing, pin, tube and seal. Slave and starter also attached.

Some Pix!
















Also thinking into the electrical. I have a few ideas about the wire tuck that I'll post when I compile my thoughts lol.
__________________

cormier is online now   Reply With Quote