View Single Post
Old 07-14-2012, 08:44 PM   #203
cormier
6th Gear Member
 
cormier's Avatar
 
Join Date: Feb 2008
Location: Mississauga, ON
Posts: 1,568
So a little confused about my Konis... Not much install info out there and the stupid instructions are all cryptic :p



The collar will only thread down this far



It bottoms out on the body of the insert





I'm wondering if that's what it's referring to here under III, it says up to 1-4mm gap?




I'm thinking of just cutting down the collar piece to fit...

Side note but is it referring to antifreeze or cold water or something on the top left of that diagram?

Also gotta find one of those tools to tighten it down or else make one or something...
__________________

cormier is online now   Reply With Quote