View Single Post
Old 04-11-2012, 10:21 PM   #74
Bullet Ride
Cars in Perpetual Repair
Bullet Ride's Avatar
Join Date: Nov 2007
Location: Guelph
Posts: 5,995
Small update

This arrived in the mail yesterday...

Building...and yes I used Jenga blocks to prop up the board while I was inserting the components with the long leads. Then I put that piece of Styrofoam from a ground beef package on top to hold the components in place while I flipped the board over. Then I soldered and trimmed the leads. A good bit of precision engineering really...

Between last night and this evening I got the kit built, I just need to get some vacuum line for the map sensor, load the firmware and maps and then (hopefully) fire up the car

I also buffed the valve cover today, I'm happy with the way it turned out...

My mom would probably tell me I need to iron my valve cover...


Last edited by Bullet Ride; 04-11-2012 at 10:28 PM.
Bullet Ride is offline   Reply With Quote