View Single Post
Old 03-12-2012, 07:24 PM   #19
Bullet Ride
Cars in Perpetual Repair
Bullet Ride's Avatar
Join Date: Nov 2007
Location: Guelph
Posts: 5,995
Originally Posted by T.Dot_E30 View Post
Not sure if you mentioned it, but you probably also want to port match the intake manifold ports to the gasket also.

I remember doing that when I built an m20, no idea if there were any gains from it, but it didn't hurt.
I did mention it. That's the plan

Originally Posted by E30M42cab View Post
Steve, you should put this m20 in a boat!

This will help you determine how much chain you will need for it to safely reach the bottom:

Just kidding, good work

I'll use the 325e block and crank as a boat anchor unless someone wants to buy them. I also have two 325e heads.
Bullet Ride is offline   Reply With Quote