View Single Post
Old 03-03-2012, 07:26 PM   #113
6th Gear Member
cormier's Avatar
Join Date: Feb 2008
Location: St. George, ON
Posts: 1,670
Today is pissin me off.

My drivers side motor mount won't fit. The bottom right hole wont line up-- think ill widen the hole on the mount a bit to get it. You can't be supposed to run 3 bolts lol

It's the bolt that looks offset

Also, my oil centre isn't 1/8 NPT. The fitting I bought to test is too small. The coolant bung for the TB heater also isn't 1/8. Piss off on both counts. I was hoping for 3/3.

All 3 holes

I can't find the bolts for the alternator mounting. I don't know which diagram I haven't checked yet.

To make matters worse, the powers been out here for over 6 hours now due to an accident on 24. This means no light, heat, drills or compressors.

cormier is offline   Reply With Quote