View Single Post
Old 06-09-2011, 10:59 PM   #188
craz azn
6th Gear Member
craz azn's Avatar
Join Date: Feb 2004
Location: Port Perry
Posts: 7,630
Send a message via MSN to craz azn
Figured I should post some of my progress in the past few weeks (months)...

I can report my welding is getting much better... but I still think I will leave the roll cage welding to the pro Once the base plates of the cage are finished, then I will know how/where to run the fuel lines so I can get started on the fuel system.

After sandpaper, wire wheel and paint:


Rippin' Proper | Youtube | Vimeo |
craz azn is offline   Reply With Quote