View Single Post
Old 11-18-2010, 05:28 PM   #13
BigD
the misanthropist
 
BigD's Avatar
 
Join Date: May 2002
Location: a house
Posts: 6,158
Quote:
Originally Posted by sb_600 View Post
hmmm not sure - it was measured by a local engine machine shop. I'm assuming they did it right. I know that when we were taking the engine apart, we could wiggle some of the pistons within the cylinders...
Ask them to tell you their procedure for doing the check, don't mention a torque plate or anything else. I'd be surprised if they even have a torque plate for your engine. If they bore it without one then they will make it oval.
__________________
BigD is online now   Reply With Quote