View Single Post
Old 11-17-2010, 01:02 AM   #133
craz azn
6th Gear Member
 
craz azn's Avatar
 
Join Date: Feb 2004
Location: Port Perry
Posts: 7,478
Send a message via MSN to craz azn
Got a bit welding done. Kinda warped the metal a bit... time to go a bit easier on the heat next time! Still need to finish the one patch to round out the corner of the valance and take care of a few small holes on the left side, then its clean up, and paint time! Also drilled a few holes to test fit the new fiberglass rear bumper. I'll try and get pics of that tomorrow.

Here is the patches for the right side (that warped like mad)...



Still gotta finish that bottom section and the right side is ready for paint!

__________________

Rippin' Proper | Youtube | Vimeo |
craz azn is offline   Reply With Quote