View Single Post
Old 06-08-2010, 12:34 PM   #4
Econobimmer Racing
BMW_7's Avatar
Join Date: Dec 2002
Location: Kiev
Posts: 8,364
Send a message via AIM to BMW_7 Send a message via MSN to BMW_7
Originally Posted by 328IScreamer View Post
reinforcement plates are a good idea
I have seen this a few times and the plates are definitly a requirment. make sure to undergaurd the plates so they don't rust, also be sure to use a pretty good sized gauge of steel so it's nice and solid.
Once welded in this should fix the issue for life.......oh and usually if one side goes your other side isn't too far behind. Insoect for cracks and if there is even a hairline I would replace both sides. It actually would be a good idea to do both sides anyway but I know it can be costly.

Thanks a lot Jon and Screamer

Well reinforcement plates go on the top of the shock tower correct? that area is fine, the problem is around the actual tower

im guessing a rear strut bar is all i need then...

Helprace, a helpdesk & community platform

Last edited by BMW_7; 06-08-2010 at 12:36 PM.
BMW_7 is offline