View Single Post
Old 06-02-2010, 01:12 PM   #16
Bullet Ride
Cars in Perpetual Repair
 
Bullet Ride's Avatar
 
Join Date: Nov 2007
Location: Guelph
Posts: 5,718
Don't rule out the 2.8 stroker.
All you need is a M52B28 crank, 130mm rods (i.e. eta rods), and stock 325i pistons, compression will be very close to a stock 325i... slightly less as the piston ends up sitting 0.5mm lower (I think) than stock. You'll also need a spacer for the crank which MM sells, and you'll have to double check clearances between the crank and the block and the crank and the piston skirts to make sure nothing will hit... people have done this build before without even mentioning this so any modifications (if any) will be minor

I'd definitely like to build one of these motors in the future... with ITB's... and some meaty cams
__________________

Last edited by Bullet Ride; 06-02-2010 at 01:15 PM.
Bullet Ride is online now   Reply With Quote