View Single Post
Old 05-31-2010, 11:54 AM   #23
Berlin
2nd Gear Member
 
Join Date: Apr 2006
Location: Waterloo/GTA
Posts: 105
Quote:
5/8" tap, 5/8" bolt, a piece of steel rod and a BFH
Tap the piece stuck in the body from underside of carand insert bolt. Go into cabin with rod and BFH and start slamming. I had to pound both sides out on my car, and it took a good few minutes of hammering... be careful not to hit the rear window with the BFH
yes, a piece did break off and i wasted some time trying to get it out with the air chisel then i remembered the 5/8tap method which popped it out in 2 seconds flat thanks man

the air hammer came in handy for taking the knurled studs out though, no problems there.

the work is still in progress, had to make a custom tool for the bushings ill post a pic later when its all done...

thanks
__________________
Berlin is offline   Reply With Quote