View Single Post
Old 11-11-2009, 11:21 PM   #2
Ted in T.O.
3rd Gear Member
 
Join Date: Jun 2003
Location: Mississauga
Posts: 501
Take the back plastic cover off the back of the seat. Take the old ones out if you have them. All you have to do is measure the correct distance down from the top of the seat and push the seat badges through the seat and bend the tabs towards the middle of the seat from the back. Make sure you apply the same pressure to both seats before you bend the aluminun tabs inwards. Easy job to do. Ted
Ted in T.O. is offline   Reply With Quote