View Single Post
Old 11-11-2009, 11:09 PM   #1
voluted
2nd Gear Member
 
voluted's Avatar
 
Join Date: May 2009
Location: Richmond Hill, Ontario
Posts: 233
FS: New 2,1/4" I.D. Magnaflow Muffler and Catalytic converter (with O2 hole)

I was going to use these on my car but i have recently decided to swap a M50 in so i will no longer be needing them.

The muffler part #14325:

4" x 9" Oval body muffler.
Magnaflow mufflers feature a straight through design that produces the smooth, deep tone they are famous for. They are manufactured from 100% stainless steel for long life and resistance to corrosion and they come with a lifetime warranty. They are available in sizes to fit every application and are available in either a fully polished or satin finish.
20" overall length.
14" body length.
2.25" offset inlet/center outlet.


The catalytic part #94035:
• Ribbed body to minimize heat distortion
• Magnaflow uses a ½" lap joint where the necks meet the body
• Stainless steel heat shield adds to converter's strength
• Universal converter is ideal for custom installations
• Manufactured on separate dies for better quality
• Monolithic honeycomb catalyst designed for maximum flow
• Heavier gauge stainless steel used from tip to tip
Inlet/outlet diameter 2.25"
Overall dimensions: 16" x 4" x 6.5"
Includes O2 sensor boss

Muffler: Asking $60
Catalytic: Asking $50


These both retail for much more than i'm asking so please don't low ball me





voluted is offline   Reply With Quote