Thread: remote wire
View Single Post
Old 11-10-2009, 08:43 PM   #2
tg07lq
4th Gear Member
 
Join Date: Oct 2009
Location: St Catharines
Posts: 792
use solder/heatshrink, or use butt connectors. the remote is a hot 12v source so you dont wanna have it arc out on you.

as for connections . it should go from remote on radio( usu. blue, most decks have 2, one for pwr antenna, one for amp, if you install and amp turns on then off, most likely wrong one, just switch them)
anyway, from radio to remote line on both amps. what setup are you going with? using factory amp?
tg07lq is offline   Reply With Quote