View Single Post
Old 06-17-2009, 08:13 AM   #7
Duct_Taper
Sticky
 
Duct_Taper's Avatar
 
Join Date: Oct 2008
Location: Ottawa
Posts: 601
As far as I know, all BMW manual transmission output flanges use the same spline/bolt pattern and seal diameter and should technically "bolt up".

I'm just not sure if the flange from the G240 has the right "height" from the surface where the flange nut sits to the surface where the guibo bolts up to allow the output shaft to stick out the right distance and index the driveshaft properly.
Duct_Taper is offline   Reply With Quote