View Single Post
Old 05-22-2009, 07:04 PM   #8
overlordjd
2nd Gear Member
 
Join Date: Apr 2008
Location: Toronto
Posts: 142
Quote:
Originally Posted by MLue1 View Post
Are you sure it is melted, when I changed my license place bulb I thought the connection had melted as well be as it turned out it was only a bit of corrosion on the bulb and contacts. I cleaned up the contact and applied some dialectric grease and everything has been fine.
You should never have condensation on the 3rd brake light due to its position not being exposed to the exterior of the car. If you do, then you have a serious issue on your hands. This is caused by poor connections from the bulb and the contact which generates heat and overtime may melt the plastic holder.
overlordjd is offline   Reply With Quote