View Single Post
Old 07-25-2007, 03:04 PM   #9
Go Topless
talltorontoguy's Avatar
Join Date: Apr 2004
Location: Under my e30
Posts: 804
No sorry, no pictures of the inside of the apron.

Basically trimmed the upper edge of apron back so that it sits just outside the lip on the inside edge of the rear bumper, then drilled and screwed the two together with self tapping screws along the long side of the bumper. For the sides that wrap around the quarter panels, I clamped the two pieces together and fiberglassed them. I also made a metal bracket that holds the two together to reinforce the fibreglass.

Obviously all of this has to be done off the car.

Join BMW Club of Canada! Click HERE

Best Engine, Bimmercruise '10 / 2nd - e30 Wild, Bimmercruise '10 / 1st - Best Cabrio, Trillium @ Tedfest '11 / 1st - e30 Wild, Bimmercruise '11 / 1st - e30 Wild, Bimmercruise '12
talltorontoguy is offline   Reply With Quote