Non-m control arm ball joint replacement
Hey guys I'm just curious. I've been doing alot of research and I know you can use e30 inner and outer ball joints on 95 m3 Control arms. I was just wondering if the non-m control arms the same as the 95 m3 ca? I have access to a press and all 4 of my ball joints are shot. I would rather replace the ball joints with e30 ones than buy new control arms.
Any help is appreciated.
just go on realoem.com and check part numbers.
Meyle HD arms are ~$100 a side, make sure it's worth going through the hassle of pressing them out.
|All times are GMT -4. The time now is 09:25 PM.|
Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Maxbimmer Copyright 2001 - 2015