maXbimmer Forums

maXbimmer Forums (http://www.maxbimmer.com/forums/index.php)
-   Wheels&Tires (http://www.maxbimmer.com/forums/forumdisplay.php?f=71)
-   -   Help with fender rolling (http://www.maxbimmer.com/forums/showthread.php?t=142480)

Nipuna 04-27-2011 07:58 PM

Help with fender rolling
 
Hi, I wanted to buy the 19'' linea corse BBS replica from wheeldude.com
the rim specs are:
Wheel Width (Inches) - 8.5F/10R"
PCD Bolt Pattern - 5x120
Offset - 30F, 22Rmm

Could someone please let me know if I would need to roll fenders if I were to put these on a 2004 M3? If so where is the best place to get the fenders rolled in Toronto area?

Also, would a 275 tire fit the rear rim properly?

Thank you very much

RockerGuy 04-27-2011 08:58 PM

Try going to tire rack and inputting the data

propr'one 04-27-2011 09:17 PM

I think they'd probably fit with rolled fenders, but wait for mystikal to confirm.

I got my arches rolled at RMP, very happy with the work.

twboy1999 04-27-2011 10:27 PM

just dont slam it, should work without rolling fender

Adrian_Lindn 04-28-2011 04:18 PM

SHould work without rolling, if it rubs go to stance factory, one of the Sponsors on this site located in Markham. Im in the same position wondering if my 265 19" rim will fit on my 2003 e46 3 series since im lowering by 1.5" apex lowering springs.

Nipuna 05-06-2011 10:01 AM

Thank you very much for your advice and help if rubbing occurs i will drop by stance factory in markham,

thanks again!*th-up*

SUPERCHARGED 05-06-2011 10:58 AM

If you need any fender work done no worries, just hit up Stance Factory. Jay and mike will take care of you. Just had my fenders pulled there and they did a great job.*th-up*


All times are GMT -4. The time now is 10:59 AM.

Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.