ACS Pedals - Pacific Mall
 

I heard someone talking about the E30 racing pedals at pacific mall for $30.00

First of all:

1. Anyone know which store or where in the building they sell them?
2. Do they have the ///M logo's, ACS logos or no logos.

Thanks

M logo's, look for a shop with a bunch of momo stuff in the window. everything looks redish. its in the north part, near the middle.

I guess Gamite is talking about Formula. Which is owned by same owner as staion28/evolution and couple of others.

(The owner used to drive s4 and now he drives carrera yellow with turbolook bodykit)

You can get ACS replica's w/ the logo engraved for like $75 US or smt. I have them in my car :)

how do u get to pacific mall from mississauga?:confused: :confused:

-401 east to kennedy exit
-drive up kennedy north to steeles
-glass builing on the north east corner.

do they have matching dead pedals as well?

No they don't but this place does

MMS Tuning

just wondering how yall installed these pedals?
i cant decide if i should take the rubber off the pedals or drill right through them.
Thanks!

drill right through the rubber.

I bought the pedals with the ///M logo today at the performance shop on the far east side of the building near the middle.

They were $55, but I lowered her down to $40.

Hopefully they feel nice :)

I'm installing these pedals tonight. YOu made a good point, I figured you should drill right through the rubber but now I'm having second thoughts.

Anyone have suggestions?

Don't drill through the rubber, it will look gay plus your adding about another inch to the height of your pedals.

Take off the rubber, drill through the plastic pedals and install them. It's more difficult, but in the end you'll be thankful you did it this way instead.

It's meant to be installed this way too.

PS I sell these pedals, the set w/ the dead pedal, the M logo ones and the ACS ones, stickers though. The dead pedal is engraved "AC Schnitzer".

Bryan

I just installed them last night.

Bought a 1/8 metal drill bit and only found problems when doing the accelerator pedal. It was hard to get the screws and the nuts on because the pedal is thick.

They look good though but I don't know how long those ///M logos will stick on for.

I havent had time to do mine yet but i was thinking to take off the rubber too...anyhow, how bad was the gas pedal...i was afraid this was gonna be a problem. does anyone know an easier way to do the gas/accelerator?

how much cdn funds?

Thanks!