maXbimmer Forums

maXbimmer Forums (http://www.maxbimmer.com/forums/index.php)
-   Wheels&Tires (http://www.maxbimmer.com/forums/forumdisplay.php?f=71)
-   -   fender work (http://www.maxbimmer.com/forums/showthread.php?t=130935)

blk325i 03-18-2010 01:17 AM

fender work
 
so i put on my 19" ch's today, the set up i had with the ltw's was just a drop in the front with H&R sports with 15mm spacer in the back, plan was to lower the rear as well when i put the rims on, but i left the stock height and spacers in the back just to see what it would look like,put them on and fell in love, who knew poking was soo good haha rear end is a little too high but it looks so good that i'm going to keep it that way, problem is it rubs waaay too much, any bump i hit on the highway and any bump i hit on the street with another person in the car

anyways just wondering what kind of fender work do i need to do to keep this set up? would i have to pull my fenders? and if i pull them would i be able to not pull them all the way? i still wanna have a bit of the fender point down
thanks in advance and my bad about the big write up

Mystikal 03-18-2010 06:43 PM

To answer this, one would need to know:

Tire size
Wheel width
Wheel offset

doogee 03-18-2010 07:44 PM

^^ True.

I had the same problem and ended up ordering a much stiffer coilover setup.

blk325i 03-18-2010 10:26 PM

235/35
19X8.5
et35(with the spacers the rears are et20)

doogee 03-18-2010 10:28 PM

Sounds like you need to go to a smaller spacer. Are your fenders rolled yet?

Personally I wouldn't pull the fenders.

blk325i 03-19-2010 02:14 PM

i'll try a ten and rolling them

thanks man


All times are GMT -4. The time now is 02:46 PM.

Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.