Amp Trouble
 

Hey Guys,

I have a rockford fosgate p10002 amplifier that powers up, gets an input signal, but there is no output. The subs are fine, i tried them with a different amp. I checked the wires. I noticed that if i disconnect one wire from a sub and touch it to the terminal again, it sparks.

Anyone have any ideas?

signal from rcas good?> put a meter on output term and get reading?

yup signal is good, the amp has two leds that light up when there is signal. i am completely stumped.

Take it out and get the amp tested for free at www.s-selectronics.com

If you've installed another amp in the same setup and it works, sounds like the amp in pouched and you need to get a new amp. Electronics have a lifespan......... or an abuse-span ...... LMAO !!

Not sure what ^^^ is,

Thanks Robb, i headed to these guys and they took care of it for me. Turns out i had blown the output transistors. :( They fixed for me and the day i was going to re-install it, my brother wrote of the car. Go figure lol. Sorry for the late thank you *th-up*