maXbimmer Forums

maXbimmer Forums (http://www.maxbimmer.com/forums/index.php)
-   Detailing & Care (http://www.maxbimmer.com/forums/forumdisplay.php?f=98)
-   -   Removing Badge (http://www.maxbimmer.com/forums/showthread.php?t=103808)

ara325 04-09-2008 01:02 PM

Removing Badge
 
Hi guys, i'd like to remove the "325 iS" badge off my trunk. I had the trunk repainted about 1 month ago (i was rear-ended) so the paint is relatively new and i'm not really worried about colour-fading underneath/around the badge area once it's removed (or should i be concerned about this?).

What's my best way to do this without causing any damage?

Any help would be appreciated.

Thanks,*th-up*
Ara

NateoriouS 04-09-2008 01:44 PM

use a heat gun to heat up the adhesive on the back.. about 2 minutes or so

use the heat gun in a left to right waving motion... so that the heat isn't concentrated on one spot for too long...

then while it's warm... use either fishing line.. or dental floss .l both work great.. and in a sawing motion.. work your way behind the badge..! until it's off... sometimes you'll need to reheat and then "saw" again..!!

after all is said and done... use "goo gone" to remove remaining adhesive... and a paper towel.... .. if you don't have goo gone... cooking oil works great too...

good luck :)

p.s. it's very easy..!!

HoldenC 04-09-2008 08:21 PM

No heat gun is necessary as it can destroy paint and possibly the body of the vehicle in mere seconds. Other than that, you may use fishing line and patience. Goo Gone is a suitable OTC product, but I prefer the professional line products such as Dupont Wax Remover (I forget the exact name now). Any kind of solvent will work, though.

Allstar_e36 04-09-2008 11:36 PM

Here's the link i used, and it worked out pretty well.
http://www.e46fanatics.com/howto/how...php?howto_id=1

gl

slemmer 04-09-2008 11:52 PM

WD-40 works good with dental floss (mint flavour)...smells good while working the adhesive off.

///MG 04-10-2008 12:10 AM

Quote:

Originally Posted by slemmer (Post 1136471)
WD-40 works good with dental floss (mint flavour)...smells good while working the adhesive off.

make sure it's the mint flavoured one! *th-up*

Michel 04-10-2008 10:16 AM

dental floss + bug&tar remover for the adhesive.

europrince 04-10-2008 11:50 AM

Quote:

Originally Posted by ///MG (Post 1136483)
make sure it's the mint flavoured one! *th-up*

what if someone doesn't like mint?? :D

Sa///M3 04-10-2008 11:55 AM

Quote:

Originally Posted by europrince (Post 1136685)
what if someone doesn't like mint?? :D

Who doesn't like mint?! :D

ara325 04-10-2008 01:01 PM

thx guys...I appreciate the help!*no-no*

slemmer 04-10-2008 05:16 PM

Dual purpose - after you debadge, chew it and it'll clean and freshen your breath (if you use mint)


All times are GMT -4. The time now is 06:04 AM.

Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.