PDA

View Full Version : DIY-How To Remove Tint


Nascar318is
10-09-2007, 06:31 PM
Well long story short I was nabbed on my way to Bav Auto. My front windows were too dark. So I had to go get it tested at a shop. I had 48 hours and then my plates would be suspended.

So today I took my tint off. It took about 40 minutes to do both sides glue and all.

Here's what you need.

Bought some Amonia and a window scraper at CT ($7 for both)
2 Razor blades for the window scraper, one already comes with it.


1st-Hot water and diswashing soap. Grab a rag and and spread it all over your windows. The heat will loosing the glue abit.

2nd-Window scraper- lift a corner of the tint and pull it all off in one shot.

3rd-I mixed 250ml of Amonia to 200ml of hot water.

4th-Spread the water and amonia all over your window(make sure you have something to wipe off the access on your door cards or anywhere else)

5th-Window Scraper I started from the bottom and worked my way up. This will take the glue off. (use one razor per side)

Once you are done, take a look from the outside of your window to see if you missed any glue, scrape the access off.

Just wash your windows with plain hot water and you are done.

Wannabe
10-09-2007, 07:48 PM
good write up.. i might take all of mine off soon.. want a change of look