View Full Version : clutch master cylinder..........

El Gato Liso
08-13-2007, 11:17 PM
is this shit easy to change?

im fully convinced that this is the reason why i had trouble changing gears to completely being unable to change gears at all (while the car is ON)

im guessing there is not enough pressure to depress the clutch...but i may be wrong but im just convinced this is the case seeing that the clutch aint releasing anything for me to change gears

08-14-2007, 12:24 AM
I think before you tackle the job you should check your brake fluid level to see if its gone down or really low since the clutch hydraulic line shares the same reservoir with the brake reservoir.

08-14-2007, 12:51 AM
if your engage point is stiff is it also related to master cylinder?

08-14-2007, 09:33 PM
when i had to change my clutch master it was becuase sometimes when i depressed the pedal the clutch would just reengage because one of the seals was leaking and i was loosing pressure. its a pita to get to though but in like 30min you can get it out just be prepared to swear alot.

08-14-2007, 09:47 PM
yea swearing can happen a couple of times lol make sure u have a line wrench cause if u use a regular wrench and it's rusty you are gonna strip it :).