PDA

View Full Version : FS: e30 parts, custom pistons, euro m20b25, worked head +MORE


ColdAccord
07-22-2007, 11:29 PM
Complete Euro m20b25

From my touring. 99k on it. EURO m20b25. just like the U.S. version, just different pistons so a tiny bit higher compression ratio (little more power). Bolts right into a 325i/is no problem. or a 325e with the necessary changes. no leaks, doesn’t burn any oil, no issues whatsoever. With clutch, flywheel, and Getrag 260 5 speed transmission, no grinds, no issues. Have pics (they’re just on my external hard drive which is at my parents house). Comes with alternator, p/s pump, starter, etc etc. everything it would normally come with (but no a/c compressor, my touring doesn’t have a/c)

$1300 w/tranny & everything

http://img.photobucket.com/albums/v727/Coldaccord/Rimsetc057.jpg

http://img.photobucket.com/albums/v727/Coldaccord/Rimsetc058.jpg




Mahle 10.2:1 pistons. Brand new, in box. Come with all rings. Designed to use “I” rods (I have a set w/60k on them in the “Used m20 parts” section below)
$535

http://img.photobucket.com/albums/v727/Coldaccord/P4290014.jpg

Fresh cylinder head. Had ~65k on it. Got it cleaned, milled, 3 angle valve job, new valve seals, valves reseated
$500

http://img.photobucket.com/albums/v727/Coldaccord/P4260008.jpg

http://img.photobucket.com/albums/v727/Coldaccord/P4290010.jpg


Performance valve springs: full set
“the increased duration of a performance cam with an aggressive grind forces the valve to open and close at a much faster rate. This rapid opening and closing at high RPM can cause "valve float". Valve float is the inability for a valve spring to close the valve fast enough to avoid piston contact.”
$245


New in box e30 rocker arm shafts (includes 2).
$70

m20b25 intake manifold with fuel rail, injectors, fpr, etc. 65k on it. $80

http://img.photobucket.com/albums/v727/Coldaccord/P5290016.jpg

http://img.photobucket.com/albums/v727/Coldaccord/P5290014.jpg

http://img.photobucket.com/albums/v727/Coldaccord/P5290013.jpg


m20b25 valve cover I started cleaning up. $30

http://img.photobucket.com/albums/v727/Coldaccord/P5290010.jpg


oil cooler and lines $50

http://img.photobucket.com/albums/v727/Coldaccord/P5290031.jpg

ColdAccord
07-22-2007, 11:32 PM
o2 sensor, m20b25, $40

http://img.photobucket.com/albums/v727/Coldaccord/P5290004.jpg


m20b25 rods 60k on them $50



m20b27 full block; crank, rods, pistons, pan, pump, all together. 155k. $90



m20b25 idle control valve. $35.

http://img.photobucket.com/albums/v727/Coldaccord/P5290002.jpg



m20b25 afm $25

throttle body elbow (goes from afm to throttle body) $8

http://img.photobucket.com/albums/v727/Coldaccord/P5290003.jpg



m20b25 throttle body and throttle position switch
$25

http://img.photobucket.com/albums/v727/Coldaccord/P5290049.jpg



spark plug wire cover. its just dirty in the pics. $8

http://img.photobucket.com/albums/v727/Coldaccord/P5290035.jpg



4.10 open differential. probably leaks. $40

http://img.photobucket.com/albums/v727/Coldaccord/P5290012.jpg

http://img.photobucket.com/albums/v727/Coldaccord/P5290011.jpg



325ix dipstick $10

http://img.photobucket.com/albums/v727/Coldaccord/P5290034.jpg



wiring harness from ’88 325ix ~65k
$75

http://img.photobucket.com/albums/v727/Coldaccord/P5290008.jpg



knee bolster. perfect shape. $30

http://img.photobucket.com/albums/v727/Coldaccord/P4290009.jpg

ColdAccord
07-22-2007, 11:32 PM
351 DME. ~65k on it. $50

http://img.photobucket.com/albums/v727/Coldaccord/P5290025.jpg



Early model (84-87) passenger side taillight. Great shape (bought from Jordan).
$35

http://img.photobucket.com/albums/v727/Coldaccord/P4290019.jpg




overhead panel, for sunroof cars. Had a bit of discoloration in the center where the rearview mirror goes, I sharpied it. Can’t even see it when installed
$20

http://img.photobucket.com/albums/v727/Coldaccord/CarParts004.jpg



late model 3rd brakelight
$10

http://img.photobucket.com/albums/v727/Coldaccord/CarParts011.jpg


All these parts are brand new in box replacement parts
head bolt set pn 11-12-1-726-478 $15
head gasket set pn 11-12-9-059-240 $45
clutch master cylinder 21-52-1-156-000 $55
clutch slave cylinder 21-52-1-116-300 $30
rear shock mount set 33-52-1-092-362 $25
transmission tail mount 22-31-1-094-916 (2) $10
guide bushing for driveshaft 26-11-1-207-096 $7
a/c compressor belt 64-52-1-466-043 $4
engine mounts (2) 11-81-1-132-323 $25 for both
coolant level sensor 61-31-1-378-320 $25
Bosch Super spark plugs (set) 12-12-9-061-869 $25

ColdAccord
11-27-2007, 03:35 PM
current list;

Complete Euro m20b25

From my touring. 99k on it. EURO m20b25. just like the U.S. version, just different pistons so a tiny bit higher compression ratio (little more power). Bolts right into a 325i/is no problem. or a 325e with the necessary changes. no leaks, doesn’t burn any oil, no issues whatsoever. With clutch, flywheel, and Getrag 260 5 speed transmission, no grinds, no issues. Have pics (they’re just on my external hard drive which is at my parents house). Comes with alternator, p/s pump, starter, etc etc. everything it would normally come with (but no a/c compressor, my touring doesn’t have a/c)

$1300 w/tranny & everything

http://img.photobucket.com/albums/v727/Coldaccord/Rimsetc057.jpg

http://img.photobucket.com/albums/v727/Coldaccord/Rimsetc058.jpg




Mahle 10.2:1 pistons. Brand new, in box. Come with all rings. Designed to use “I” rods (I have a set w/60k on them in the “Used m20 parts” section below)
$535

http://img.photobucket.com/albums/v727/Coldaccord/P4290014.jpg




Performance valve springs: full set
“the increased duration of a performance cam with an aggressive grind forces the valve to open and close at a much faster rate. This rapid opening and closing at high RPM can cause "valve float". Valve float is the inability for a valve spring to close the valve fast enough to avoid piston contact.”
$245


New in box e30 rocker arm shafts (includes 2).
$70


o2 sensor, m20b25, $40

http://img.photobucket.com/albums/v727/Coldaccord/P5290004.jpg


m20b25 rods 60k on them $50


m20b25 idle control valve. $35.

http://img.photobucket.com/albums/v727/Coldaccord/P5290002.jpg

ColdAccord
11-27-2007, 03:36 PM
m20b25 throttle body and throttle position switch
$10. the spring on the plenum of the tb is broken. everything is is good.

http://img.photobucket.com/albums/v727/Coldaccord/P5290049.jpg



spark plug wire cover. its just dirty in the pics. $8

http://img.photobucket.com/albums/v727/Coldaccord/P5290035.jpg



4.10 open differential. probably leaks. $40

http://img.photobucket.com/albums/v727/Coldaccord/P5290012.jpg

http://img.photobucket.com/albums/v727/Coldaccord/P5290011.jpg


351 DME. ~65k on it. $50

http://img.photobucket.com/albums/v727/Coldaccord/P5290025.jpg


Early model (84-87) passenger side taillight. Great shape (bought from Jordan).
$35

http://img.photobucket.com/albums/v727/Coldaccord/P4290019.jpg




overhead panel, for sunroof cars. Had a bit of discoloration in the center where the rearview mirror goes, I sharpied it. Can’t even see it when installed
$20

http://img.photobucket.com/albums/v727/Coldaccord/CarParts004.jpg



late model 3rd brakelight
$10

http://img.photobucket.com/albums/v727/Coldaccord/CarParts011.jpg


All these parts are brand new in box replacement parts
head bolt set pn 11-12-1-726-478 $15
clutch master cylinder 21-52-1-156-000 $55
clutch slave cylinder 21-52-1-116-300 $30
rear shock mount set 33-52-1-092-362 $25
transmission tail mount 22-31-1-094-916 (2) $10
guide bushing for driveshaft 26-11-1-207-096 $7
a/c compressor belt 64-52-1-466-043 $4
engine mounts (2) 11-81-1-132-323 $25 for both
Bosch Super spark plugs (set) 12-12-9-061-869 $25

sicilianace
11-28-2007, 07:23 PM
Buddy, will the afm fit a 87 325i....if so...... interested.....will u ship to Toronto... do u have paypal acct>>>.... also like the cone air filter...will u sale me.....the afm...the bracket(hardware) to connect the cone air filter also!!!!

Thanks,
Anthony

ColdAccord
11-28-2007, 08:13 PM
hm, you don't have the Private Message option on.

yes, it will fit a 325i. I'd rather leave the air filter with the motor if that's ok. I will ship to ON at your expense, and my paypal is Nerdigger@aol.com. thanks

supernaught
11-29-2007, 09:26 AM
hey guys, ill probably be in buffalo on the 17th-19th but could only bring up small stuff. Cross border fee will apply ;)