View Full Version : FS: ***Turner/Conforti Chip***

uber e36
06-10-2007, 12:07 PM

I'm selling my Turner/Conforti Chip.

It's application is for M50 motors (325i) with the 413DME. So if you have a 325 that was built 1/95+ this is the chip for you!

I'm only selling because I'm going to swap in new cams and so I need a different chip now...

Going rate is $150. They sell for $299USD new.


P.S. From the Turner Website:

"Description: Our most popular product, hands down ! Our dyno tuned engine performance chips developed by TMS and software expert Jim Conforti, provide the ultimate in performance. Adding a performance chip to your car is the easiest, most cost effective way of increasing your BMWs performance with NO downsides. TMS performance chips are supplied with detailed instructions and are user installed in about an hour. The performance chip optimizes ignition timing and fuel curves which results in increased horsepower and torque. We have dyno tested these chips and compared it to all the others and found it to provide the most horsepower and usable torque. Must use 91 octane or higher gasoline."


06-10-2007, 12:40 PM
will it fit a 01 330ci?

uber e36
06-10-2007, 01:53 PM
It will fit the vehicle mentioned in my first post.

06-10-2007, 01:54 PM
will it fit a 01 330ci?

no it will only fit e36's before 1995 (cause of EWS II)

uber e36
06-10-2007, 03:28 PM
no it will only fit e36's before 1995 (cause of EWS II)


It will fit any 325 e36 that was built starting in January 2005.