PDA

View Full Version : RMP motors in Bolton


propr'one
02-20-2006, 09:28 PM
After showing up 6 hours late on saturday, i finally showed up at RMP motors this morning (only an hour late this time:D)

I needed some service done,
-Have my clutch kit installed
-Remove the CDV (thanks justin, tomek, everyone who told me to do this)
-Install rear shock mounts.

All of the above were done quickly and very professionally. Rocco then took certain liberties, and was I happy he did.

-Fixed my (botched) attempt at installing a m3 diffuser
-Fixed my power steering
-Fixed certain random tranny components (he humoured me by explaining to me exactly what he did, I think i got most of it)

I also asked Rocco to install my new driver side window regulator. He told me that my old one was fine, and that the issue with the window must be the motor, and he couldn't fix it because i only brought him the regulator.
http://www.zippyvideos.com/7668325923875876/mvi_0604/
The above is my window, which Rocco told me he didn't fix (:D sure you didn't)

-During clutch install, it was noticed that my slave cylinder was leaking, Rocco had one on hand, and it was installed.

RMP motors was generally very professional, met and exceeded my expectations, great communication. RMP completed all the work I had asked to be done, and then some, in exactly the amount of time that I was quoted. The prices were far below that of other independant shops.

Would I go back? Yep. thursday. need ball joints:D

RMP motors located in Bolton, which is about 20 minutes from the jane & 401 intersection. Traffic gets a little heavy during rush hour, so it can take a little longer, so I suggest avoiding rush hour when going out there.

All in all, great experience, great service, great prices.

Thanks Rocco*th-up*

RMPMOTORS
02-20-2006, 11:36 PM
No problem Ivan, I am very glad to see that you are happy with your car. Since the window motor is weak I lubed up the regulator and seals while I was inspecting it, to make the motor last as long as possible.


Rocco *th-up*

propr'one
02-23-2006, 06:29 PM
Just got back from RMP again. This time Rocco and Mark got to work on my front balljoints and bushings. My balljoints were about as loose as a young street... they were very loose:D. bushings needed to be replaced too. Showed up at RMP an hour late (as per usual,) at least this time i had an excuse of being rear ended. Rocco was nice about me coming an hour late and still got to work on the car right away. He even let me stick around and watch while he was working. All the work was done with the utmost care, and professionalism, something i've come to expect from RMP. As always with RMP, the best part of it is getting back on highway 50 to head home. wow. nuff said


This time, Rocco managed to fix the squeeking in my brakes. Im actually completly lost as to how that's even remotely possible, as I was watching what he was doing the whole time. Who knows, mabye its just the cold weather.

Rocco also put in a new serpentine belt and a AC belt, and when I started bitching about my H1 bulbs being way too dim in my foglights, he has some on hand which were installed. (they look much better)

I also made it back from RMP today at 4:30, in the middle of rush hour, in about 19 minutes. the way rocco tunes/fixes cars, i dont think that really surprises anyone

pricing was insanely low, just like all other work i've had done at RMP. Rocco's a great mechanic, just needs to sharpen up supply/demand skills, oh well, im not complaining:)

thanks again Rocco*th-up*

RMPMOTORS
02-23-2006, 06:37 PM
Okay then Ivan, next time when I make a quote I will double it before I tell you the price so that I can be competitive with other shops pricing...:idea:

AMI Motorsports
02-23-2006, 06:50 PM
Yup RMP is the pimp :cheers:

RMPMOTORS
02-23-2006, 11:40 PM
Thanks AMI *smoke*

RMPMOTORS
02-27-2006, 11:42 PM
Do you need that moulding Ivan?

myndgone
03-12-2006, 01:15 PM
FINALLY got my sub & amp installed thanx to Rocco @ RMP.

Price was the lowest I could find (and trust me, i looked for a while).
Professional and clean install.


Good job, dude! *th-up* *th-up*



I got BASS again!!!!!! *wiggle* *par-t* *drink*

propr'one
03-12-2006, 01:29 PM
rocco, i do need that moulding, if its ok just go ahead and order it, i'll need it 100%


senad i wired up my own amp & sub with vadim. ****ing e39 drivers refuse to work on their own cars.

at least you chose the best*th-up*

RMPMOTORS
03-13-2006, 09:15 PM
When do you want to pick it up?

propr'one
03-14-2006, 03:09 AM
Friday would probably be best. That cool? Do you want me to pick it up from you guys or "the source"?

myndgone
03-14-2006, 08:44 AM
hey propane, go on saturday, meet u there, biyatch...:D

urNOTready!
03-14-2006, 10:55 AM
I'm also getting them to install my full m3 swap this month.. can't wait*wiggle*

RMPMOTORS
03-14-2006, 03:43 PM
I will have it tonite! (Tues) Come up anytime to pick it up!!

propr'one
03-15-2006, 12:04 AM
Rocco, I'll call tomorrow or thursday to confirm, but tentivley friday?

Miguel
03-15-2006, 01:32 PM
I couldn't put it any better... on 2 of my cars RMP has:

swapped springs, shocks, RSM, and ADj. LCA's.
fixed a window that wasnt closing properly
rear brakes
tranny fluid
oil change
swapped front bumpers
swapped nose panels
coolant flush/fill
install thermostat
installed/swapped radio (better than when 12 Volt originally did it!!!)
installed side mouldings
installed HID kit
installed ZKW's
and im sure there is more im forgetting...

A++ to Rocco, Mark, & my gay lover (inside joke... don't get any ideas...), and everyone else at RMP

RMPMOTORS
03-16-2006, 09:54 PM
Who is this "Gay Lover"???

propr'one
03-17-2006, 01:47 AM
:eek: oh noes!!!11

propr'one
03-17-2006, 03:31 PM
Alright, so in my life long quest to be like justin and know everything about everything, i saw an opportunity to learn something i know absolutley NOTHING about -- homosexuality.

There were rumours of sightings near RMP motorworks in bolton, so i went to go investigate...

When i got to RMP, i noticed some stylish cars, and a very clean shop. this reminded me of some late night tv informing me that "homosexuals are an industrious and clean people people, and have been since they came here from France"

Could I be on the right track?

I continued my search tirelessly, but unfortunatly, the heterosexuality of everyone at RMP was obvious. My dream of meeting a homosexual was shattered. I cursed miguel's name for giving me misinformation!

On my way out, I casually started bitching about my hand being broken. So Rocco tweaked the door-opening mechanism so i wouldn't have pull so hard to open the door with my broken hand. Also some issues with my sunroof were cleared up, and now i know what has to be done to fix them. Rocco also hooked up some parts for insanely cheap, much like he always does.

All in all it was a pretty decent trip. RMP motorworks is a great place to get your car fixed, but not a great place to study homosexuals:(


Thanks for the parts hookups Rocco*th-up*

Miguel
03-19-2006, 11:16 PM
Who is this "Gay Lover"???
pfffttt... who you kiddin'?!? THE SUPERMODEL!! http://smiliesftw.com/!/baboosh.gif

Anyways.. just to recap... Rocco & friends are good guys and a great shop. Give em a call when you need work done.

RMPMOTORS
03-21-2006, 09:55 PM
ooooooh, The SUPERMODEL...:D

Flynner333
01-07-2013, 07:12 PM
Thank you all for your posts about RMP. My battery died and with an upcoming lease-end, I dreaded a visit to the dealer and was desperate for an alternative. After reading this post about Rocco & RMP, I decided to call.

They took me next day and did not disappoint. They were courteous, competent and reasonably priced. Now that I have a non-dealer mechanic, it makes my lease-end decision easy - Rocco, you'll be seeing me every 8,000 kms!