View Full Version : How did you debadge?

11-05-2005, 10:16 AM
Ok lets here how you debadged your car, any and all problems you ran into etc.. im going to be doing this i need answers ASAP!!!

Justin e36
11-05-2005, 10:49 AM
heat gun
plastic putty knife
once it was off, the remaining glue was rubbed off with rubbing alcohol on a cotton cloth. then the car was washed.

took around 3 minutes to heat it up and peel it off slowly. don't hold the heat gun too close either. you don't want the glue to get TOO soft so it makes a mess.

11-05-2005, 11:08 AM
heat gun eh? does that mean a hair dryer would work as i dont have a heat gun?

11-05-2005, 11:16 AM
Hair dryer would probably work, but you'd have to hold it on high heat for much longer.

Easiest way i've done it...... just take a piece of wire/fishing line and just slide it behind..... takes no time..... and like was mentioned above, just wipe the remaining glue with alcohol

Justin e36
11-05-2005, 11:19 AM
^ thats true. I've used fishing line on another car before as well. Just saw it back and forth. too bad I didn't think of that when I debadged years ago.

11-05-2005, 11:20 AM
sweet deal thanks for the info, hey justin, how did you get your headliner dyed?

Justin e36
11-05-2005, 11:36 AM
took it off, dyed it with a fabric dye and a brush. afterwards it was a bit stiff. had to take another brush after it dried and ran it across to loosen up the fibers. it's been around a year with the dye and no problems.. still pitch black, but not as pimp looking as suede.

11-05-2005, 12:12 PM
Do what Dildomatic said, or use dental floss.

11-05-2005, 01:16 PM
I was just going to say, dental floss works really well..

Its just 3M double sided tape


11-05-2005, 03:57 PM
all done, debadged and lookin clean. i used fishing line rubbing alcohol cotton cloth and my thumb nail. came out good. now i just need to wash my car as i have 2 clean spots on a filthy car

11-06-2005, 03:38 PM
hair dryer and dental floss

11-06-2005, 03:44 PM
i jsut took it off without anything.