PDA

View Full Version : 320i mounts w/ UUC TME etc


Autotechnica
10-21-2004, 06:15 PM
I have the following for sale. Sold to highest bidder...

new BMW 320i mounts + UUC aluminum tranny mount enforcers.

Stiffest OEM mount available. Also includes the UUC aluminum enforcers for extra stiffness.

Paid approx. $100 after shipping + taxes.

Fits all E36's including M3. Check UUC site for additional applications.

Uses a 10mm stud, will only fit 318 with modifcations to the mounting locations. No nuts included.

Make offers.

Miguel
10-21-2004, 09:03 PM
why are you selling these? are they used at all?

Autotechnica
10-21-2004, 09:14 PM
why are you selling these? are they used at all?

I had them on my car for like 5 min.. took them off because UUC doesn't like 318's.

Bry

Miguel
10-21-2004, 09:18 PM
I had them on my car for like 5 min.. took them off because UUC doesn't like 318's.

Bry
what didnt fit? the 320i mount or the tranny enforcer?

Autotechnica
10-21-2004, 09:22 PM
what didnt fit? the 320i mount or the tranny enforcer?

It fit, just didn't work well with my setup. I had problems because I have a unique setup.

The 320i mount and enforcer go together so they were used together. No wear on the bushings at all, they are new! All I did was start the car and drive around the block then remove them.

KIRASIR
10-22-2004, 05:19 AM
50? ;)

It fit, just didn't work well with my setup. I had problems because I have a unique setup.

The 320i mount and enforcer go together so they were used together. No wear on the bushings at all, they are new! All I did was start the car and drive around the block then remove them.

Autotechnica
10-22-2004, 10:28 AM
50? ;)

Someone already offered me $55 before you did, $65 and it's yours!

Bry

Autotechnica
10-22-2004, 10:29 AM
I also have the UUC red bushings, but the studs are stripped. If anyone wants to spend the time to restud them, I'll sell them cheap.

sthomas
10-22-2004, 10:56 AM
I'm in for $60

Autotechnica
10-22-2004, 11:57 AM
Any other offers?

KIRASIR
10-22-2004, 12:45 PM
What is unique in your setup? What modifications are required?

SL

It fit, just didn't work well with my setup. I had problems because I have a unique setup.

The 320i mount and enforcer go together so they were used together. No wear on the bushings at all, they are new! All I did was start the car and drive around the block then remove them.

Autotechnica
10-22-2004, 12:49 PM
What is unique in your setup? What modifications are required?

SL

You have to grind off the nub on the tranny brace (must-do for all e36's). You also have to enlarge the hole on the mounting points for the tranny (318's only), because it will only accept 8mm studs where as the 6 cyl model can accept 10mm studs.

I believe that's the getrag 200 models, the M44 may have the 250?

Bry

Autotechnica
10-24-2004, 08:04 PM
sold

I apologize for not getting back to a lot of people who were interested. I've been very busy stripping down the M3, so basically whoever shows up the quickest and with the most cash gets it. :)