View Full Version : pics of my engine bay
04-12-2004, 03:36 AM
but he is not clean !!!
04-12-2004, 05:15 AM
Looking good my man...im liking the blue and especially the turbo...that exaust wrap on the turbo piping is no good tho man...loose that...get it treated or ceramic coated.
04-12-2004, 05:27 AM
how does she run?????
04-12-2004, 02:06 PM
04-12-2004, 03:22 PM
he running good but little bit leak of oil , and i will install my injector to night . and this week i turn on the boost.
04-13-2004, 02:25 AM
04-13-2004, 02:34 AM
the tubo makes up for the dirt and grime...very nice
04-13-2004, 02:51 AM
WTF is a tubo? :D
04-14-2004, 01:17 AM
where did you find the turbo?
04-14-2004, 08:50 PM
i found it at garrett . from the distributor of my country
04-15-2004, 09:21 AM
Could you tell me what the type is of that Garret and what the max boost is?
Do you have pics of your exhaust manifold?
04-15-2004, 09:56 PM
the turbo is a garrett t4 the turbo number is TB4129 , he is good for about 550 hp , me i will run to star at 5 -7 psi but after i put my forged low compression piston i will make anough boost to do 300 HP , for the manifold i made it my self .
04-15-2004, 10:01 PM
the IC look very bad!!!!
04-16-2004, 03:44 AM
UGLY vacumm hoses and tube protectors, turn them in black man!! how much boost are you runing? that's a ETA right?
04-16-2004, 08:25 AM
Do you have a pic of the ic itself?
I am doing the same to my 2.3 M20 engine with adjusted compression. I am going to use an KKK K04 turbo.
04-17-2004, 04:27 PM
about the IC
04-19-2004, 10:43 AM
Where did you buy that IC and how much did it cost you?
04-20-2004, 12:29 AM
about IC i buy it from : www.streetmachineperformance.com
iI found this guy in quebec but they ship out were do you wont. In US , west canada, ontario. i pay it 500 $$$ CAN its sheap for the quality of this IC the IC size is 26x6x3 and hes good for about 450 horse.
vBulletin® v3.8.1, Copyright ©2000-2015, Jelsoft Enterprises Ltd.