PDA

View Full Version : auto to 5 spd conversion


Dreamer
02-17-2004, 04:53 PM
Hi guys, I was wondering if somebody can tell me the stuff that I need to convert my 92 325i auto to a 5 spd tranny. Do I need to change the ECU? and what are the cost for this mods.

Your help will be much apreciated.
Ciao...

kiley_sean
02-18-2004, 02:47 AM
No need to change the ECU. There is a computer for your Auto. tranny, but you don't need to take it out. There isn't a whole lot of wiring going on with the swap, mostly bolts, patience, and a small hand to install the clutch master cylinder!!!!

The cost varies depending on whether you are performing your own labor or not, and the acquirement of parts.

I would usually say, " Do a seach.", but I don't know how well the subject is covered here on Maxbimmer.

Here is a parts list I did on DTM awhile back (look a few posts down):

http://www.dtmpower.net/forum/showthread.php?s=&threadid=63458&highlight=tranny+swap

Hope that helped give you an idea of what is in store.

sonic07
02-18-2004, 05:46 AM
you can try calling Mantis Racing in Oakville (905 844 6219) they perhap will be able to give you a quote over the phone. they specialize on German cars. as well as engine swaps on bimmer.

good luck.

Dreamer
02-18-2004, 09:30 PM
thanks for all your help guys
you guys are the best

Thanks again