PDA

View Full Version : How hard is it to install/replace


FadingAwayNJ328
07-17-2003, 03:10 PM
how hard will it be to replace my driver side front fender....would i be better off doing it myself or taking it to a shop to do? and if i was to do it myself, how would i do it?

FadingAwayNJ328
07-17-2003, 03:47 PM
anybody? lol

blkm3
07-17-2003, 06:00 PM
it is not too hard to do . it depends on how good you are with the ratchet . I did mine 2 mths ago a few screws here and there then you are set . remember the fender slips under the hood.

djcontra
07-17-2003, 06:34 PM
Blkm3: do you need to remove the moldings on the fender, and unbolt the wheel well screws at all?

blkm3
07-17-2003, 07:21 PM
the plastic wheel well is not screwed on it is just kinda pushed in on top of the fender. If your new fender does not come with the molding then yes you need to remove it . it is easy just use a screw driver and with some patient you should be able to get it off . on the clips there are little plastic things that look like condoms which you should keep this is for water etc...

djcontra
07-17-2003, 07:41 PM
Oh ok, but there's not like a hidden screw under the molding right? that's all I was wondering about. I hate when I get snagged by hidden things like that, especially with electronics :)