any machinists on the forum

[dcramer]

I'm looking for someone to make seat brackets.

[craz azn]

It is going to be waaayyyy cheaper to buy something and bolt together than getting something custom (unless you DIY). There is a set of Momo sidemounts on kijiji for 60$, start there maybe?

[Smitty]

LOL when I saw this I thought it said 'masochists.'

[Bullet Ride]

Are the dimensional requirements such that you can't use angle iron and drill some holes in it?

[dcramer]

It is going to be waaayyyy cheaper to buy something and bolt together than getting something custom (unless you DIY). There is a set of Momo sidemounts on kijiji for 60$, start there maybe?

I am just having trouble paying 225 or more for the VAC billet aluminum. It starts out life as a 20 dollar piece of aluminum.

Dave

[dcramer]

Are the dimensional requirements such that you can't use angle iron and drill some holes in it?

Well you need a number of things to make this work in a daily driver.

Sliding rails, min 100 each, side brackets, something to bolt your seat belt to. Then if you decide to use an anti-sub it is easier to bolt the bracket to the VAC like mounts.

[dcramer]

LOL when I saw this I thought it said 'masochists.'


And yes we are

[dcramer]

So I can get them made for 150 a side, anyone interested ?

[paddyhong]

So I can get them made for 150 a side, anyone interested ?

Are they going to have the same adjustability or just enough to mount it the way you want? And does it include the side mounts?

[dcramer]

If I did them they would be the same as these
http://www.machtschnell.com/products/?mode=view_product&product_id=165

No does not include side mounts.

I may opt to save money by not tapping all of the holes, you could tap just the ones you are going to use.