View Full Version : Alarm issues

07-14-2010, 07:00 PM
I lost my remote to turn off the alarm for my 1992 325i. So now when i get in the car and turn it on all i get is the hazard lights going off and the alarm. I cut the wire for the alarm so atleast its not loud. Now how do i fix this hazard light issue?

Here is some pictures of the wiring im looking at, if anyone can tell me which to cut to fix this that would be great as i dont have the money and cant find a new remote lol

Also i know it says 2007, my camera is broken or something

07-18-2010, 11:20 AM

Just locate this box and unplug it!


should be on the right side of your pictures.

07-20-2010, 01:10 AM
I couldnt find that when i first looked but i will look again. thanks!

07-20-2010, 12:10 PM
In the passenger's footwell there should be a speaker grill to the right and a board panel attached to the top that runs under the glovebox. Remove this panel to get access to the alarm system and disconnect the box. I have the same issue as you (no remotes).

Are there any alarm systems that plug directly into the stock alarm harness?

07-21-2010, 12:44 AM
The 12 pin connector that connects the module to the car should be on the left side behind that mess of wires, if you find that just disconnect it, did u check under where the blue connector is to see if your module was hiding there ?....i know some sit there..if not i think the LED light plugs into the module of the alarm(not 100% sure) so maybe if u follow that wire it may lead you to the module