PDA

View Full Version : How to re-install rear bumper trim


GMGERMANMOTO
06-03-2009, 10:20 PM
Does anyone out there know how to re-install the rear rubber bumper trim piece on an 88 325i with stock "diving board" bumper? The clips are there... Do I hook the rubber trim from the bottom of the clip & pry it over the top part of the clip?
I can't help thinking that there must be a simple procedure involved here.. I just don't want to start off in the wrong direction & do more harm than good..lol

:confused:

WillieE30
06-08-2009, 09:32 AM
When I replaced mine I think I just removed the clips and then inserted them one by one into the molding and then snapped the molding with clip into the appropriate holes...I hope this helps...the clips were easily removed from the bumper..........Good-luck Bill